ClubCJ - The CJ Lancer Club

hi everyone i was wondering if you could help me with advice. my vr cj lancer had an electrical fire in the dash on the passenger side. ive replaced all the plastics wiring ecu etc. Is the wiring Dash loom all the same for es vr and vrx?

I tried to turn on the car it reads system error ??
i have power to the windows, key, sunroof lights dash aircon ect..

it does also say that it needs asc ? the switch isnt working ?

and the car wont turn over

I think the ez and vr, sx, vx are all the same, not sure if vrx ecu is the same as they are 2.4l and have slight differences

What ecu are you using? All harnesses should be the same. Only difference you should find is if there is keyless entry, as the ecu needs to be programmed for it.

its got an es dash wiring loom, vr engine wiring loom and vr ecu and key with imobiliser. The ETAS-ECU is the original from the car im guessing because its different to what was replaced, it all has to be reprogrammed to remove the system error because Vins wont match?

i cant get access to the new wiring ETAS-ECU because i purchased the car with all the wiring supplied. sucks

the ecu was changed and engine harness also. i know the key is reading because the car lock and unlocks and lets me try to crank it over

I faced same problem... Can anybody hook me up... My fuse box was fully damaged which one is in the dash on the passenger side... Then I buy the same Fuse Box and install it... Now my Headlights Doors and signals all working perfectly... but Key is not working... and when i use Manual key and I tried to start my car then i see it says """System Error""" and no responds from engine... and I also see key is not working... I am in a big Problem... is that is Software issue..?? I hope everyone help me...

My Lancer Model is """Mitsubishi Lancer EX 2010 Elegance Package"""