***** ALERT - Nominations for your new ClubCJ Committee can be made here *****

Ralliart hood

Exterior Parts/Accessories & Modifications.

Moderators: Moderators, Senior Moderators

Dr No0b
Lancer Newbie
Lancer Newbie
Posts: 20
Joined: Sun May 19, 2019 11:16 pm

Ralliart hood

Postby Dr No0b » Tue Jan 07, 2020 10:11 pm

Will a Ralliart hood fit and fenders fit my 09 Lancer es

User avatar
bumblebee
Post Monster
Post Monster
Posts: 3059
Joined: Mon Jun 12, 2017 7:22 pm
Location: Australia

Re: Ralliart hood

Postby bumblebee » Wed Jan 08, 2020 5:40 am

The bonnet does , I have one on mine
Never tried the fender , I wouldn't be surprised if it does fit

Dr No0b
Lancer Newbie
Lancer Newbie
Posts: 20
Joined: Sun May 19, 2019 11:16 pm

Re: Ralliart hood

Postby Dr No0b » Thu Jan 09, 2020 11:06 pm

If it get a hood do I need anything else to put it on or does it go straight on

User avatar
lancerdarryl
Lancer MASTER
Lancer MASTER
Posts: 1929
Joined: Wed Jul 14, 2010 3:10 am
Location: Newcastle NSW Australia

Re: Ralliart hood

Postby lancerdarryl » Fri Jan 10, 2020 5:40 am

They're a straight swap so you shouldn't need anything else.
Evolution X MR+ Lancer VRX Sportback +LA Lancer GSR
"Don't back off until you hit something"

User avatar
bumblebee
Post Monster
Post Monster
Posts: 3059
Joined: Mon Jun 12, 2017 7:22 pm
Location: Australia

Re: Ralliart hood

Postby bumblebee » Fri Jan 10, 2020 5:59 am

You will need an extra person to help you remove it and that's it
One the bonnet it dup follow the water line on the left, the black Bose to the windscreen washers
Follow that hose
It goes to a 90 degree plastic elbow
The hose will disconnect there pretty easy
It just pulls a part
Lift the bonnet up
Shove some rubber under the rear corners of the bonnet between the bonnet and windscreen incase you drop it when undoing bolts
Goes someone to hold the font while loosen of bolts on one side
Do not remove bolts all the way
Loosen of bolts on the other side
Do not remove all the way
Once all bolts are backed off and someone holding it
Then you can remove all bolts
Do 2 on one side
Goto other side and help hold bonnet and do other side
So both of.you should be holding bonnet and llift it away

When bring new bonnet back
You can lower it on to the rubber you laid on windscreen before to get yourself into position
A pair of things works best for rubber
One person on each side of bonnet
Lift it and put bolt in most of the way on all four
Do then up snug but not firm
Need to check alignment
Align the bonnet with back bolt off a touch and wiggle bonnet
Or gentle tape with rubber mallet on edges
Check the latch at front
Is it lined up?
If all lined.up tighten up 4 X bolts under bonnet on hinges
Plug in black hose to the windscreen washers
Close bonnet
Test windscreen washers
Done
Enjoy


Return to “Exterior”

Who is online

Users browsing this forum: No registered users and 22 guests