I spoke to Ben from Benchmark. Possible blown sensor circuit in the ecu. So not a cheap fix. I should have listened to my gut feeling and stopped anyhow hopefully i can get a second hand one and flash map from the car and load into different ecu. If its going to cost me to much I'll go motec from Po...

Ok well, I stuffed up. I looked around and thought I would try to wire the innovate water temp gauge to the stock wiring and sensor located near the thermostat. Well, the car didn't like that. I the red wire from innovate to pin 26 on which is the sensor wire, The other to the ground. When I started...

If we can get more, I am going to get an Evo X rear deck mat.

So for logo they do Lancer EX, Ralliart and the Evo X ones. Dash mats with logo, Floor mats with logo and Rear Deck mats. 3 orders of anything and they will ship to Australia Here is the seller https://www.carousell.sg/inbox/1409186366?%243p=e_sg&_branch_match_id=1001562212017862717&utm_medi...

Not a very good photo but it says Lancer EX - This logo can be put on the rear deck mat.

They do Ralliart ones I think, I sent a message to the seller.

I dont think so I can ask.

Can confirm 3 orders

Hi everyone I found someone who can make rear deck carpet mats with a logo. They look really good from overseas but they won't just sell me one item. I am trying to find out what the minimum order is too Australia. I think min order is 5 items. They also do floor mats. Ralliart logo and Evo X logo h...

I finally got around to taking a couple of pics of the Ortiz custom pod 2 gauge pillar pod. It's really well done, just has a design flaw in not being able to keep gauges and locked in tight against the windscreen etc. I had to trim a fair bit of material from behind the pods to allow wires to be ru...

I originally purchased a ortiz custom pod for two gauges that sit on the pillar. Very well made but I was disappointed with how the pillar sat. it had too much weight with one gauge in it and kept hanging down. That's why I went with the carbon panel. I'll post a picture of the pillar tonight when I...

Nah its in the panel below. it comes out through the top of dash mat

I am getting ready for my flex tune in Feb with Benchmark. I have partially installed 2 x Innovate gauges. 1 x Powersafe Boost Air/Fuel Ratio gauge and 1 x Water Temperature & Battery Gauge. I still have to hook up the wideband o2 sensor the bung was really tight on the exhaust so I need to heat...

You should be able to buy a USB retention cable. Contact Aerpro Australia, They may have something

New from Amayama $88 plus freight.

https://www.amayama.com/en/part/mitsubishi/7620a139ha